─５─
5. Securely align the lower surface of the side under spoiler
①
to the
body, and press firmly so that there is absolutely no gap on side
surface of the side under spoiler. (Refer to the cross-section view)
6. Temporarily fix the side under spoiler with tape.
7. Set the templates along the bodyline and attach with tape.
8. Remove the rivet (1) temporarily installed in Step 3, and detach the
side under spoiler with the templates left affixed to the vehicle.
9. While keeping the templates set to the shape of the body, punch
marking holes through the center of the template using a punch.
(12 locations)
10. Peel off the templates
(12 locations).
11. Wrap the drill bit with duct tape as shown in the figure.
①
Align lower surface
firmly with body
②
Align with body with no gap
Side under spoiler
Tape
Body
Vehicle front
＜
Cross-section view
＞
Duct tape
1
ｍｍ
Drill
Over-drill protection
Drill
Drill bit
(shoulder
)
Tape
Tape
Tape
Vehicle front
Vehicle front
Tape
Drill-hole center position
Template
•
Be careful when handling drills and other sharp objects.
•
To prevent scratching and over-drilling, always wrap the drill
bit with duct tape.
CAUTION
Drill hole center
position
•
Be careful of the alignment of the side under spoiler with the
body, and make sure that it contacts the lower surface of the
vehicle body and its height is equal from front to back.
CAUTION
•
Make sure the templates are not twisted or detached when
affixing them to the body.
CAUTION
•
When detaching the side under spoiler, be careful that the
templates do not slip or become ripped.
CAUTION
•
Punch holes in the center of each drill-hole mark with the
templates left affixed.
NOTE
