Mazda CX-9
㧙
6
Front console box removal
1. Remove a screw (1 location).
2. Pull the front console box outward and detach clip A (1 location)
and hooks (3 locations).
3. Disconnect the accessory socket connector.
4. Remove the front console box.
Center panel removal
1. Remove the screws (2 locations).
2. Pull the center panel outward and detach clips A (10 locations).
3. Disconnect the hazard switch connector and climate control unit
connectors.
4. Remove the center panel.
Car navigation unit removal
1. Remove the bolt (1 location).
2. Remove the screws (4 locations).
3. Pull the navigation unit outward slowly and detach clips A (2
locations) from the dashboard.
4. Disconnect all the navigation connectors and antenna feeder,
then remove the car navigation unit.
x
When installing the navigation unit, make sure that the
wiring harness and antenna feeder are not caught between
the navigation unit and dashboard. If the wiring harness or
the antenna feeder is caught between the navigation unit
and dashboard, it may cause malfunctions.
CAUTION
x
The ventilator grilles will be installed to the shaded areas
shown in the figure. Therefore, if a wiring harness is in the
areas, it could get caught and damaged. When installing
the center panel, completely press in the wiring harnesses
of the hazard warning switch connector in the direction of
the arrow so that the wiring harnesses will not be caught.
CAUTION
Front console box
Screw
Clip A
Hooks
Vehicle front
Center panel
Climate control unit connectors
Clip A
Hazard switch connector
Screws
Vehicle front
Center panel
Hazard switch
Connector wiring harness
Vehicle front
Car navigation unit
Screw
Clip A
Antenna feeder
Navigation unit
connectors
Vehicle front
Clip A
Screw
Bolt
Tightening torque: 6.9
̆
9.8 N
㨯
m
[ 71
̆
99kgf
㨯
cm, 62
̆
86 in
㨯
lbf ]
