Body & Accessories
Lighting Systems
Initialization procedure for auto-leveling control module
•
An initialization procedure for the auto-leveling control module has been added. When
this procedure is activated, the auto-leveling control module detects the height of the
unloaded vehicle via the signal from the auto-leveling sensor and stores it as a reference
value in the control module memory.
•
The auto-leveling control module must be initialized when any of the following
procedures has been performed:
–
Front combination light replacement
–
Auto leveling control module replacement
–
Auto leveling sensor removal/installation
–
Instrument cluster replacement
–
PJB replacement
–
Replacement of suspension components or work that effects vehicle height
•
In order to activate the initialization procedure for the auto-leveling control module,
connect M-MDS to the vehicle and select the option
Toolbox
→
Electrical
→
Exterior
Lighting
→
Headlamp
→
Auto-leveling Sensor Re-zero Procedure
.
NOTE:
In case the initialization procedure using M-MDS is not possible, it can also be
performed by connecting terminal B in the DLC-2 to ground (refer to the workshop
manual for the detailed procedure).
Service Training Mazda3 F/L
09-25
Summary of Contents for 3 Facelift 2006
