Mazda 3 Facelift 2006, Training Manual

Page: 60 / 94

Security and Locks Body & Accessories
Service and Repair
Programming additional card keys with two or more card keys
•
If two or more registered card keys are available, additional card keys can be
programmed without using M-MDS. A maximum of six card keys can be programmed.
NOTE: Do not program card keys while M-MDS or any other computer devices are in the
vehicle. Make sure all card keys are operational and have good batteries.
NOTE: Steps 3 to 6 below must be completed within 30 seconds after inserting the auxiliary
key in the ignition lock.
1. Bring the two registered card keys (key 1 and key 2), and the card key to be
programmed into the vehicle and close all doors.
2. Insert auxiliary key in the ignition lock.
3. Turn ignition switch to the ON position.
4. Push the UNLOCK button on card key 1 once.
5. Push the UNLOCK button on card key 2 once.
6. Turn ignition switch to ACC then back to ON three times.
7. Open and close the driver’s door three times. The door lock actuators will lock once,
then unlock to confirm that programming mode is active.
8. Push the UNLOCK button on the card key to be programmed twice. The door lock
actuators will lock once, then unlock to confirm that programming was successful.
Programming additional card keys with M-MDS
1. Establish communication between M-MDS and the vehicle.
2. Select the option Toolbox
→
Body
→
Security
→
PATS Functions .
3. Select the option “Program Additional Card Key” and carry out the security access
procedure (read out M-MDS outcode, and input corresponding incode).
09-12 Service Training Mazda3 F/L