3
4
Seats
MEMORY SEAT PROgRAMMiNg SWiTChES
To Program the Driver’s Seat Position
1
Park vehicle.
2
Adjust seat to desired position using the slide/tilt and recline switches.
3
While holding the SET button in, push one of the three (3) programming
buttons until a beep is heard. Programming is now complete. Program
remaining two buttons as desired.
NOTE:
You can also program one seat position for each advanced key/retractable
type key used with the vehicle. See Owner’s Manual for programming instructions.
To Move the Seat to a Programmed Position
•
With driver’s door OPEN and ignition OFF
, push and release one
of the programmed buttons (1, 2, or 3) when entering the vehicle.
OR
•
With driver’s door CLOSED and ignition ON
, push and hold one of
the programmed buttons (1, 2, or 3).
NOTE:
Memory seat functions DO NOT operate when driver’s door is OPEN and
ignition is ON, when driver’s door is CLOSED and ignition is OFF, or when the vehicle
is in motion.
ELECTRONiCALLY OPERATED DRiVER SEAT
Slide/Tilt Switch
Seat can be moved back
and forth, raised, lowered,
or tilted with this control.
Recline Switch
Push forward or
backward to adjust
seatback angle.
Lumbar Adjustment
Push switch to
increase or decrease
lumbar support.
Rear Seat Occupant Exiting
Push and hold the top of the driver’s power seatback folding
switch to move the seat forward and to fold the seatback forward.
Push and hold the bottom of the driver’s power seatback folding switch until
the seat returns to the original position and a confirmation beep is heard.
On all passenger seats and manual driver’s seat (except Recaro), use the lever
located on the rear of the seat along the lower edge of the seatback.
RECARO SEATS
Seatback angle
(RECARO seat)
Lean forward slightly, lift the lever, and then
release it at the desired position.
Seat Warmer
Front Seat Warmer
The driver and front passenger seats can
be warmed by pushing the applicable seat
warmer switch while the ignition is ON.
• Push seat warmer switch ON (light
illuminated) or OFF.
NOTE:
The seatback recline lever may be used on all passenger seats and manual
driver’s seat (except Recaro).
FUEL
DOOR
RELEASE
(located on floor in front of driver’s seat)
To open, pull the fuel
door release.
FUEL REqUiREMENTS
91 octane fuel is required. If 91 octane fuel
is not available, fuel as low as 87 octane
can be used temporarily for emergency
purposes. Use of fuel lower than 91 octane
can decrease performance, cause knocking/
engine noise and can deteriorate shift
quality. Refueling the vehicle with correct
octane fuel a couple of times will restore
vehicle performance and shift quality.
www.MazdaUSA.com
280340_11a_RX-8_SSG_081010.indd 4-5
8/10/10 3:09 PM
