2
Pre-assembly of Fender Strakes
1. Clean fender area using soft cloth, soap and water.
2. For the upper strake, insert the diamond locator
(back side of strake) in the slot second row from the
bottom, third from the front side. Figure 1.
3. Assemble the strake grille and strake with bolt and
retainer through chosen slots. Be sure to identify the
fender strakes by the ID stamp on the bottom.
Figure 3. Do not completely tighten. Keep retainers
in upward position.
4. For the lower strake, insert the diamond locator in
the slot second row from the bottom, first diamond
from the front side. Figure 2.
3
Final Assembly of Grille to Vehicle
1. Snap grille back into vehicle fender. Make sure all 6
clip positions snap in position (shown in Step 1,
Figure 2.)
2. Reach your hand into fender well (shown in Step 1,
Figure 2) and rotate clips in downward position.
Using allen wrench, tighten screws completely until
snug.
3. Repeat step 1, 2, and 3 for opposite side grille.
3/31/04
Page 2 of 2
Rev. A
4
Final Assembly
1. Reassemble fender well using (4) plastic scrivets removed in Step 1. Figure 1.
2. Confirm strakes are flush to grille and conforms to vehicle’s sheet metal
3. Wipe vehicle and strakes of any fingerprints, using soft cloth.
FRONT
UPPER
FIGURE 1
FIGURE 1
FIGURE 2
FIGURE 3
BOLT
RETAINER
STRAKE
FRONT
ALLEN WRENCH
RU — RIGHT UPPER
RL — RIGHT LOWER
LU — LEFT UPPER
LL — LEFT LOWER
LOWER
0000-8L-K01
