0000-8E-N31 Rev G
02/24/2016
4 of 8
C) Tape flat washers (ITEM C) into position over mounting locations
on inside of each mounting plate. (These washers will be clamped
between the side plates and frame rails.)
D) Preassemble four M12 bolts (ITEM B) with a conical toothed washer (ITEM A).
Note: Be sure teeth on washer are facing away from the bolt head.
E) Place plates into position and loosely fasten to weldnuts. Note: Be sure
both plates are positioned so they angle towards the center of the vehicle.
STEP 3 - CONTINUED FROM PAGE 3
TOOLS: FLATHEAD SCREWDRIVER, TAPE
03
Plates angle inward
A - Conical Washer
Rear of vehicle
B
