1032601C-3/4
17
INSERT CABLE INTO THE MAST.
THE TABS ON THE LOCK-CAP
SHOULD NEST INTO THE HOLES
IN THE MAST END.
LOCKING CAP
POSITION:
MAKE SURE THE
OPEN PART OF THE
LOCK-CAP FACES
DOWN.
COMPRESS THE TABS TO
INSTALL THE LOCK-CAP.
13
12
CRADLES HAVE A FRONT AND BACK.
THE CRADLE WITH YAKIMA
SHOULD GO ON LAST, WITH
“YAKIMA” FACING OUT.
THE SMOOTH DEPRESSION ON RIGHT
FRONT SIDE MUST FACE TOWARD YOU.
YOUR PRODUCT INCLUDES
A STOP-RIVET. FLEX
CRADLES AND PUSH OVER
STOP-RIVET ON MAST.
SECURE CRADLES TO MAST.
• INSERT BOLT AND
WASHER (RIGHT TO
LEFT) INTO ROUNDED
DEPRESSION ON
UNDERSIDE OF CRADLE.
• ATTACH NUT
• USE A FLATHEAD SCREWDRIVER.
• TIGHTEN EACH CRADLE CAREFULLY.
15
USE A FLAT TOOL TO PRY OFF THE END
CAP FROM THE MAST.
REMOVE THE PLUG
IN THE MAST.
16
REMOVE THE END CAP.
19
18
THE LAST CRADLE MUST BE
BEHIND METAL RIVET. REMEMBER
TO TIGHTEN THE CRADLE.
LOOSEN THE OUTSIDE
CRADLE WITH A FLATHEAD
SCREWDRIVER.
MOVE THE CRADLE UNTIL IT STOPS
BEHIND THE METAL RIVET.
14
ATTACH CRADLE STRAPS.
BE SURE STRAP
IS HOOKED
ONTO CRADLE.
POSITIONING CRADLES: YOU
MAY WANT TO ADJUST CRADLES
ONCE BIKES ARE LOADED.
20
CHECK THE CRADLES.
GRAB CLOSE TO THE BAR WITH BOTH HANDS.
TIGHTEN IF THERE IS MOVEMENT.
