The clearance is checked by wheel pumping at hung out wheel. Check the size of wheel convergence after adjustment of bearing
tightness.
13. During increased free stroke of steering wheel and clearance absence in the links of steering wheel to demount steering mechanism
and make adjustment.
14 To check and to adjust free motion of pedal of clutch when it is necessary.
15 To check the drive lever of gear-box in the drive. When there is a necessary make adjustment, remove clearances.
16 In 60-80 000 km to make adjustment of bearings tightness of driving bevel gears, axle differential gears and output shaft of
intermediate axle.
17 To check the condition and adjustment of the rope of overflow valve and to adjust the angle of platform lifting
18 To drive out the plug from the hydraulic cylinder bottom and pour out sediment
19 To check condition of guiding semicircles of hydraulic cylinder of platform lifting.
Make the grease of the truck according to hematological map.
Test of the truck after maintenance.
After maintenance check the work of aggregates, devices and truck systems during the movement or diagnosis station.
Season maintenance
Make next actions additionally to the above listed autumn and spring works:
1 Change the oil, fuel and cooling fluid, corresponding to the season.
2 Change filtered element of dryer of pressed air (once per 1-2 years)
Truck lubrication
Perform lubrication of units and truck aggregates according to hematological map of lubrication.
Perform lubrication of units and power units (engine, clutch, gear - box) according to the specifications of manufacturing plant.
To the driver’s attention!
Oils for gear-box ZF and periodicity of oil change is given in ZF specifications or in
ТЕ
–
М
L 02 specifications, which can be found in
service centers or in internet site www.zf.com
Summary of Contents for 534035
