14
TROUBLESHOOTING
If you experience
Possible Causes
Solution
Dryer Results (cont.)
Load too hot
Load removed before cool down
portion of cycle complete.
Allow the dryer to complete the cool down portion of the cycle
before removing the load.
Using Timed Dry cycle with a high
temperature setting.
Select an Sensor Cycle with a lower heat setting to avoid overdrying
the load.
Dryer Displaying Code Message or Indicator Is Lit
“PF” (power failure)
The drying cycle has been interrupted
by a power failure.
Touch the START key to clear the PF error message; then press and
hold the START key to resume cycle.
“L2” Diagnostic Code (low
or no line voltage condi-
tion)
There may be a problem with your
home power supply, keeping the
dryer’s heater from turning on.
The dryer will continue to run when this diagnostic code is present.
Touch any pad to clear the code from the display and return to the
estimated time remaining.
Try the following:
•
Check to see if a household fuse has blown or circuit breaker
has tripped. Electric dryers use two household fuses or breakers.
Replace the fuse or reset the circuit breaker.
•
Confirm that the power cord is properly installed. Refer to
the Installation Instructions for details.
•
Select a Timed Dry heated cycle, and restart the dryer.
If the message persists, consult a qualified electrician.
“F# E#” (F1 E1, F3 E1,
etc.) variable service
codes.
The dryer is in need of service.
If a code beginning with an “F” appears in the display, alternating
between F# and E#, the dryer control has detected a problem that
requires service. Call for service.
First try the solutions suggested here or visit our website at www.maytag.com/product_help –
In Canada www.maytag.ca for assistance and to possibly avoid a service call.
Summary of Contents for YMEDB755DW0
Page 3: ...3 ...
