26
2.
Place drying rack inside dryer drum, positioning the back wire on the ledge of the inner
dryer back panel. Push down on front edge of drying rack to secure at the front of the
dryer.
A
B
A. Dryer rack front edge
B. Dryer back panel
3.
Put the wet items on top of the drying rack. Leave space between the items so air can
reach all the surfaces.
NOTE:
Do not allow items to hang over the edge of the drying rack.
4.
Close the door.
5.
Press the POWER/CANCEL button.
6.
Select a Timed Dry cycle and temperature (see following chart). Items containing foam,
rubber, or plastic must be dried on a clothesline or by using the Air Fluff temperature
setting.
DRYER CARE
Cleaning the Dryer Location
Keep dryer area clear and free from items that would obstruct the flow of combustion and
ventilation air.
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the floor
for a garage installation.
Failure to do so can result in death, explosion, or fire.
Cleaning the Lint Screen
Clean the lint screen before each load. The control panel has an indicator light to remind you
to clean the lint screen before each load. A screen blocked by lint can increase drying time.
IMPORTANT:
■
Do not run the dryer with the lint screen loose, damaged, blocked or missing. Doing so
can cause overheating and damage to both the dryer and fabrics.
■
If lint falls off the screen into the dryer during removal, check the exhaust hood and
remove the lint.
Every load cleaning
1.
The lint screen is located in the door opening of the dryer. Pull the lint screen straight up.
Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet
lint is hard to remove.
2.
Push the lint screen firmly back into place.
