Maytag T1, User Manual

Page: 17 / 64

ANTI-TIP BRACKET
LEVELING LEG
16
Oven Door
CAUTIONS:
•
Do not place excessive weight on or
stand on an open oven door. This
could cause the range to tip over,
break the door, or injure the user.
•
Do not attempt to open or close
door or operate oven until door is
properly replaced.
•
Never place fingers between hinge
and front oven frame. Hinge arms
are spring mounted. If accidentally
hit, the hinge will slam shut against
oven frame and cause injury.
To remove:
1. When cool, open the oven door to the
broil stop position (opened about four
inches).
2 . Grasp door at each
side. Do not use the
door handle to lift.
3. Lift up evenly until
door clears hinge arms.
To replace:
1 . Grasp door at each side.
2.
Align slots in the door with the hinge
arms on the range.
3. Slide the door down onto the hinge arms
until the door is completely seated on the
hinges. Push down on the top corners of
the door to completely seat door on
hinges. Door should not appear crooked.
NOTE: The oven door on a new range may
feel “spongy” when it is closed. This is nor-
mal and will decrease with use.
Oven Window
To protect the oven door window:
1
. Do not use abrasive cleaning agents such
as steel wool scouring pads or powdered
cleansers as they may scratch the glass.
2. Do not hit the glass with pots, pans,
furniture, toys, or other objects.
3. Do not close the oven door until the oven
racks are in place.
Scratching, hitting, jarring or stressing the
glass may weaken its structure causing an
increased risk of breakage at a later date.
Maintenance
Leveling Legs
CAUTION:
•
Be sure the anti-tip bracket secures
one of the rear leveling legs to the
floor to prevent the range from
accidentally tipping.
The range should be lev-
eled when installed. If the
range is not level, turn the
plastic leveling legs, lo-
cated at each corner
of the range, un-
til range is
level.
Oven Light
BULB COVER
WIRE
RETAINER
CAUTIONS:
•
Disconnect power to range before
replacing light bulb.
•
Use a dry potholder to prevent
possible harm to hands when re-
placing bulb.
•
Be sure bulb is cool before touch-
ing bulb.
•
Do not touch hot bulb with a damp
cloth as this may cause the bulb to
break.
To replace:
1. When oven is cool, hold bulb cover in
place, then slide wire retainer off cover.
NOTE: Bulb cover will fall if not held in
place while removing wire retainer.
2. Remove bulb cover and light bulb.
3. Replace with a 40 watt appliance bulb.
4. Replace bulb cover and secure with wire
retainer.
5. Reconnect power to range. Reset clock.
CAUTION:
•
Do not store plastic, paper prod-
ucts, food or flammable materials
in this drawer. The drawer may
become too warm for these items
when the oven is in use.
The storage drawer can be removed to
allow you to clean under the range.
To remove:
1. Empty drawer and pull out to the first
stop position.
2. Lift up the front of the drawer.
3. Pull out to the second stop position.
4. Grasp sides and lift drawer up and out.
To replace:
1. Fit the ends of the drawer glides into the
rails in the range.
2. Lift up the front of the drawer and
gently push in to the first stop position.
3. Lift drawer up again and push until
drawer is closed.
Storage Drawer
LEVELING LEG
CIRCUIT BREAKER SWITCH
Convenience
Outlet
(C
ANADIAN MODELS ONLY
)
The convenience outlet is located on the
lower left side of the backguard. Be sure
appliance cords do not rest on or near the
surface element. If the surface element is
turned on, the cord and outlet will be
damaged.
The convenience outlet circuit breaker may
trip if the small appliance plugged into it
exceeds 10 amps. To reset the circuit
breaker, press the switch located on the
lower edge of the backguard.
ANTI-TIP BRACKET