17
3.
Remove plastic cover from gas pressure regulator cap.
4.
Turn gas pressure regulator cap counterclockwise with
a 5/8" (1.6 cm) combination wrench to remove.
NOTE:
Do not remove the spring beneath the cap.
5.
Turn over the gas pressure regulator cap and reinstall on
regulator so that the hollow end faces out and the marking
“
ê
LP” is facing the direction shown in the above drawing.
6.
Replace plastic cover over gas pressure regulator cap.
To Convert Surface Burners (Natural Gas to Propane
Gas)
1.
Remove burner cap.
2.
Remove the burner base.
A
B
C
D
Side view before
Side view after
E
NG
LP
NG
LP
A. Plastic cover
B. Gas pressure regulator cap with solid end facing out
C. Gas pressure regulator cap with hollow end facing out
D. Washer
E. Gas pressure regulator cap
A. Burner cap
B. Burner base
C. Alignment pins
D. Igniter electrode
E. Gas tube opening
3.
Apply masking tape to the end of a 9/32" (7 mm) nut driver
to help hold the gas orifice spud in the nut driver while
changing it. Press nut driver down onto the gas orifice spud
and remove by turning it counterclockwise and lifting out.
Set gas orifice spud aside.
4.
Remove the orifice spuds shipped in the literature package
in the oven. Gas orifice spuds are stamped with a number on
the side or top. Replace the Natural gas orifice spud with the
correct Propane gas orifice spud.
Refer to the following chart for correct Propane gas orifice
spud ratings and to spud holder card for proper placement.
Propane Gas Orifice Spud Chart for Surface Burners
Placement
Burner
Rating/Type
Size (mm)
ID Number
LF
14,200 BTU
1.08
108AM
LF (ST)
15,000 BTU
1.08
108AM
LR
5,000 BTU
0.64
064AM
RF
14,200 BTU
1.08
108AM
RR
8,000 BTU
0.84
084AM
CTR
8,000 BTU
0.84
084AM
NOTE:
Refer to the model/serial/rating plate located on the oven
frame behind the top left-hand side of the oven door for proper
sizing of spuds for each burner location.
5.
Place Natural gas orifice spuds in the orifice spud bag.
IMPORTANT:
Keep the Natural gas orifice spuds in case
of reinstallation with Natural gas.
6.
Replace the burner base.
7.
Replace burner cap.
8.
Repeat steps 1 to 7 for the remaining burners.
A
B
C
D
A. Igniter electrode
B. Orifice spud
C. Orifice spud holder
D. Screws
XX
X
A
X
X
X
A. Stamped number
D
E
C
B
A
