7
CYCLE SIGNAL
Use this button to turn the signal indicating the
end of a drying cycle on or off.
6
CYCLE STATUS INDICATORS
The Cycle Status Indicators show the progress of a cycle.
Sensing
The Sensing indicator will light during Sensor Cycles to
indicate that the moisture sensor on the dryer is operating.
This indicator will not light during Timed Cycles or options
such as Wrinkle Prevent
™
.
Wet
The load is still wet and/or the cycle just started.
In the Custom Refresh or the Auto Refresh Steam Cycles
(on some models), the Wet indicator comes on after the
water has been sprayed into the drum, 4-5 minutes into the
cycle. The Wet light illuminates until the dryer goes into Cool
Down with 1 minute of time remaining.
Damp
This indicator is used with Sensor cycles to show that the
load is partially dried and items that you may wish to hang
up or iron while still damp may removed.
Cool Down
The dryer has finished drying with heat, and is now tumbling
the load without heat to cool it down and reduce wrinkling.
Steam model shown
Done
This will indicate that the selected cycle has ended and the
load may be removed from the dryer. If the Wrinkle Prevent
option has been selected, the dryer may continue to tumble
the load, even if the Done indicator is lit.
Wrinkle Prevent
™
This indicator will light if the Wrinkle Prevent option has been
selected and is running. The dryer will continue to tumble the
load for up to 90 minutes after the cycle has ended.
Steam (on some models)
This indicator will light when the Steam function is active.
NOTE:
Steam is not available on all models or on all cycles.
Controls Locked
This indicator will light when the controls are locked. Press
and hold the Cycle Signal button for 3 seconds to unlock.
Control Lock
If the dryer is running:
Press and hold the Cycle Signal button for 3
seconds to lock the controls of the dryer and
avoid an accidental change in cycle options
or settings during a drying cycle. Press and
hold again for 3 seconds to unlock.
To enable the Control Lock feature if the dryer
is off, it is not necessary to press POWER
before activating the Control Lock feature.
Summary of Contents for MEDE201Y
Page 3: ...3...
