24
3.
Move the door strike
Using a T25
®
screwdriver, remove the two screws securing
the door strike to the door frame of the dryer. Rotate the strike
180° and attach to the opposite side of dryer door frame with
the two screws removed earlier, as shown.
†
®
TORX, T20, and T25 are registered trademarks of Acument Intellectual Properties, LLC.
DOOR REVERSAL (OPTIONAL)
The following instructions are for models with round and
square-shaped doors.
#2 Phillips screwdriver
Min. 8" (203 mm) long
TORX
®
, T20
®
,
and T25
®
†
screwdrivers
Tools needed:
1.
Disconnect wiring from door
Using a Phillips screwdriver, remove middle screw in hinge.
Disconnect wiring. Tuck wiring into opening.
REVERSE DOOR SWING: ROUND-SHAPED DOOR
2.
Remove door from dryer
IMPORTANT:
If the protective film has not yet been removed
from the dryer, peel the film from the dryer door before
proceeding.
Using a T25
®
screwdriver, remove the four screws securing
the door hinge to the dryer and lift the door up and out to
remove. Place the door on a soft towel or other non-scratch
surface.
DOORS WITH ELECTRICAL WIRING:
ALL DOORS:
Summary of Contents for MED5630HW
Page 2: ...2 DRYER SAFETY...
Page 30: ...30 S CURIT DE LA S CHEUSE...
