Refrigerator
too cold
Refrigerator
too warm
Freezer too
cold
Freezer too
warm
Turn
refrigerator
off
10
Using the Controls
Initial Temperature Setting
Temperatures are preset at the factory at 38° F (3° C)
in the refrigerator compartment and 0° F (-18° C) in
the freezer compartment.
Adjusting the Control
24 hours after adding food, you may decide that one or
both compartments should be colder or warmer. If so,
adjust the control as indicated in the
Temperature
Control Guide
below.
•
Do not
change either control more than one degree
at a time. Allow temperature to stabilize for 24 hours
before making a new temperature adjustment.
Set the refrigerator control to next
higher number by pressing the
pad.
Set the refrigerator control to next
lower number by pressing the
pad.
Set the freezer control to next higher
number by pressing the pad.
Set the freezer control to next lower
number by pressing the pad.
Press the
freezer
pad until
“OFF” appears in the display. Press
the in either the freezer or
refrigerator section to turn back on.
The red Replace light will illuminate when the filter is
100% used OR 12 months have elapsed since the filter
was installed. A new filter should be installed
immediately when the Replace light is illuminated.
After replacing the filter, press and hold the
Reset Filter
pad for
three
seconds. The Order and Replace lights
will blink and then go off.
Light
The Light feature can be used to provide light
to the dispenser area. The light feature is
automatically activated and the indicator light
illuminates. There are two methods available for
lighting the dispenser - Auto and Continous.
The Auto light function activates the dispenser light at
half-power
when the light sensor detects that the light
levels in the room are low.
The Continuous light function provides light until
deactivated. The On indicator light will illuminate.
To Activate Auto Light:
Press the
Light
pad
once
. The Auto indicator will
illuminate.
To Activate Continuous Light:
Press
Light
pad again. The On indicator light will
illuminate.
To Deactivate Auto or Continuous Light:
Press the
Light
pad a
third
time. This will turn off the
dispenser and indicator light.
Vacation Mode
The Vacation Mode feature causes the freezer
to defrost less frequently, conserving energy.
The Vacation Mode indicator light will illuminate when
the feature is activated. To activate, press the
Vacation
Mode
pad. To deactivate, press the
Vacation Mode
pad again OR open either door. The indicator light will
go off, and return to normal operating mode.
Temperature Control Guide
Water Reset Filter Status Indicator Light
When a water filter has been installed in the
refrigerator, the yellow Order light will
illuminate when the filter is 90% used OR 11 months
have elapsed since the filter has been installed.
