17
Auto Temp Control
Auto Temp Control electronically senses and maintains a uniform wash and rinse water
temperature. Auto Temp Control regulates incoming hot and cold water and is automatically
turned on when a cycle is selected. (See “Preset Cycle Settings” in “Cycles.”)
Auto Temp Control is available with Warm/Warm, Warm/Cold and Cold/Cold settings. The
water temperature in the Hot/Cold setting depends on the water temperature at the water inlet
faucets.
■
Auto Temp Control ensures consistent cleaning.
■
Today’s detergents work well at temperatures above 60°F (15.6°C).
Delay Wash (on some models)
You can use the Delay Wash feature to delay the start of a wash cycle for up to 8 hours
(depending on your model).
1.
Load the washer and fill the dispensers.
2.
Close the washer lid.
3.
Press POWER.
4.
Select the desired Cycle, Modifiers and Options.
5.
Press DELAY WASH. 1H (one hour) will be displayed in the time display window. The
indicator light for Delay Wash will glow.
6.
For a longer delay time, press DELAY WASH. The Start time will increase by 1-hour steps.
7.
Press START. The countdown in hours to the wash cycle will show in the time display
window and the indicator light will begin to flash.
NOTE:
The Start indicator light will not flash when Delay Wash is chosen. You must press
Start to initiate a countdown for the cycle to begin.
To change the Delay Wash time:
■
Press PAUSE/CANCEL.
■
Press DELAY WASH to select the desired delay time.
■
Press START to begin the countdown.
To cancel Delay Wash:
Press START again to begin the cycle right away or press PAUSE/CANCEL twice.
Options
Use these pads to select the desired options for your wash cycle.
Stain Cycle
This option provides enhanced cleaning action for tough stains. The Heavy Duty cycle
automatically includes Stain Cycle. Choosing Stain Cycle will add approximately 10 minutes
to a cycle. Stain Cycle should be started on a dry load only and cannot be selected after the
tub has started filling with water.
Stain Cycle may be selected as an option with other cycles. See table for details.
Extra Rinse
An extra rinse can be used to aid in the removal of detergent or bleach residue from garments.
This option provides an additional rinse with the same water temperature as the first rinse.
This is the default rinse setting for the Whites cycle.
Pre Soak
Use this option for set-in stains and soil that need extra time for removal. Soaking in this
washer is different than in a conventional washer. The washer sprays the load with water and
detergent at extra-low spin speed followed by a brief pause. This action is repeated. Pre Soak
cycles through a series of sprays followed by a pause to allow the detergent to work on the
soils. The Pre Soak feature is followed by the selected cycle. Using Pre Soak will extend your
wash cycle.
Cycle
Stain Cycle
(Adds time to the wash cycle)
Whites
Option
Super Wash
Default
Normal
Option
Wrinkle Control
Option
Colors/Jeans
Option
Delicate
Not available
Handwash
Option
Rinse & Spin
Not available
Spin Only
Not available
