Maytag 4KMVWC410JW1, Use And Care Manual

Page: 12 / 40

12
WASHER MAINTENANCE
Replace inlet hoses after 5 years of use to reduce the risk
of hose failure. Periodically inspect and replace inlet hoses
if bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses, mark the date of replacement
on the label with a permanent marker.
NOTE: This washer does not include inlet hoses. See the
Installation Instructions for more information.
WATER INLET HOSES
WASHER CARE
Recommendations to Help Keep Your Washer
Clean and Performing at its Best
1. Always use High Efficiency (HE) detergents and follow the
detergent manufacturer’s instructions regarding the amount
of detergent to use. Never use more than the recommended
amount because that may increase the rate at which
detergent and soil residue accumulate inside your washer,
which in turn may result in undesirable odor.
2. Use warm and hot wash water settings sometimes (not
exclusively cold-water washes) because they do a better
job of controlling the rate at which soils and detergent
accumulate.
3. Always leave the washer lid open between uses to help dry
out the washer and prevent the buildup of odor-causing
residue.
Cleaning Your Top Loading Washer
Read these instructions completely before beginning the
routine cleaning processes recommended below. This washer
maintenance procedure should be performed, at a minimum,
once per month or every 30 wash cycles, whichever occurs
sooner, to control the rate at which soils and detergent may
otherwise accumulate in your washer.
Cleaning the Inside of the Washer
To keep your washer odor-free, follow the usage instructions
provided above and use this recommended monthly cleaning
procedure:
Recommended Cycle for Cleaning the Washer
Refer to the “Cycle Guide” for the optimal cycle for cleaning
the inside of the washer. Use this cycle with Washer Cleaner or
liquid chlorine bleach as described below.
Begin procedure
1.
Clean Washer Cycle Procedure (recommended for best
performance):
a. Open the washer lid and remove any clothing or items.
b. Place a Washer Cleaner tablet in the bottom of the
washer basket.
c. Do not add any detergent or other chemical to the washer
when following this procedure.
d. Close the washer lid.
e. Select the cycle recommended for cleaning the inside of
the washer.
f. Press the START/STOP/PAUSE/UNLOCK LID button to
start the cycle.
NOTE: For best results, do not interrupt cycle. If cycle must
be interrupted, press START/STOP/PAUSE/UNLOCK LID
once. After the cycle has stopped, run a Rinse & Spin cycle
to rinse cleaner from washer.
WASHER CARE (cont.)
2. Chlorine Bleach Procedure (Alternative):
a. Open the washer lid and remove any clothing or items.
b. Add 1 cup (236 mL) of liquid chlorine bleach to the
bleach compartment.
NOTE: Use of more liquid chlorine bleach than is
recommended above could cause washer damage
over time.
c. Close the washer lid.
d. Do not add any detergent or other chemical
to the washer when following this procedure.
e. Select the cycle recommended for cleaning the inside
of the washer.
f. Press the START/STOP/PAUSE/UNLOCK LID button to
start the cycle.
NOTE: For best results, do not interrupt cycle. If cycle must
be interrupted, press START/STOP/PAUSE/UNLOCK LID
once. After the cycle has stopped, run a Rinse & Spin cycle
to rinse bleach from washer.
Cleaning the Dispensers
After a period of using your washer, you may find some residue
buildup in the washer’s dispensers. To remove residue from
the dispensers, wipe them with a damp cloth and towel dry.
Do not attempt to remove the dispensers or trim for cleaning.
The dispensers and trim are not removable. If your model has
a dispenser drawer, however, remove the drawer and clean it
before or after you run the Clean Washer cycle. Use an all-
purpose surface cleaner, if needed.
Cleaning the Outside of the Washer
Use a soft, damp cloth or sponge to wipe away any spills. Use
only mild soaps or cleaners when cleaning external washer
surfaces.
IMPORTANT: To avoid damaging the washer’s finish, do not
use abrasive products.