SAFETY
– Important Guidelines
RISK OF EXPLOSION
•
Explosive gases may escape during charging. This is normal, but please follow the
following guidelines:
•
Do not charge near flames or sparks
– do not smoke in the area.
•
Ensure adequate ventilation during charging.
•
Keep the charging area completely clear of combustible materials.
•
Do not leave charging batteries unattended for long periods or overnight.
•
Do not allow battery to overheat by exceeding 40
0
C.
•
Store and use indoors only,
do not expose to rain or moisture.
•
The charger is designed to charge 12v Lead-Acid & AGM batteries with capacities as shown in the
specifications table. Charge only one battery at a time. Do not use with non-rechargeable batteries.
•
This charger should not be used as a continuous DC power source or for any purposes other than
those listed
– any other use will invalidate warranty.
•
Ensure that cables are regularly inspected and kept in good condition.
•
Never use the appliance if the charger, mains lead, plug, output leads or crocodile clips are
damaged.
•
Replacement of the mains cable should only be carried out by the manufacturer. There are no user-
serviceable parts in this product other than the fuse in the plug and the output fuse under the
charger.
•
Always disconnect mains supply before connecting and disconnecting the battery leads.
•
Follow instructions for safe use
– electrical discharge from batteries can be dangerous.
•
Battery electrolyte is acidic and likely to cause burns. The use of safety goggles and gloves when
working with lead acid batteries is strongly advised.
•
This appliance is not for use by a person (including children) with reduced physical, sensory or
medical capabilities or lack of experience or knowledge.
PREPARATION OF THE BATTERY
Refer to the vehicle manufacturer
’s handbook for battery maintenance and charging guidelines.
CONNECTION
Always disconnect the mains supply before making or breaking battery connections. Connect the
battery clips to the battery in the following order:
1.
Connect the positive charging lead (RED) to the positive post of the battery (, +ve or P).
2.
For vehicles with the battery still installed: connect the negative charging lead (BLACK) to the
vehicle chassis (marked -, -ve or N), well away from the battery, fuel line, hot or moving parts.
For batteries removed from the vehicle: Connect the negative charging lead (BLACK) to the negative
post of the battery (marked -, -ve or N).
After connecting the clips, rotate them slightly so as to remove any dirt or oxidization, thus ensuring
a good contact.
1
2
3