77
1
114
29
107
107
6
114
77
2
136
77
114
76
7
ENG
Assemble the parts carefully as any damages or defects occurring due to mistakes made at the time
of assembly are not covered by the warranty or guarantee. Therefore, read through the assembly
instructions carefully before you start assembling, follow each assembly step exactly as described
and keep to the correct sequence of assembly as instructed.
Assembly of the training device must be carried out thoroughly by adults only. Assemble the training
device in a location which is level, clean and clear of obstructions. Two people are required to carry
out the assembly. Training can only start when the training device has been fully assembled.
Step 1: Assembly of the Front Stabilizer
Place the front stabilizer (6) onto the main frame (1) and fix it with four flat washers M10 (77), four
spring washers (114) and four cap nuts (29).
Then place the U bracket (2) to the bottom end of the main frame (1) and fix it using one Allen head
bolt M10x20 (107), a flat washer M10 (77) a spring washer M10 (114) and a nylon nut (76) on each
side. Make sure to use the front borehole of the two holes on the left and right of the end of the main
frame.
Make sure the device is standing level on the floor by adjusting the knob (136).
Assembly