Maxxus Multi-Press 6.0, Installation & Operating Manual

Page: 6 / 24

4
4
2
1
3
3
3
6
Carefully unpack all delivered parts. Have someone there to help you as some of the training device parts are
bulky and heavy.
Check that all the parts and fixing materials (screws, nuts, etc.) have been delivered.
Assemble the parts carefully as any damages or defects occurring due to mistakes made at the time of assem-
bly are not covered by the warranty or guarantee. Therefore, read through the assembly instructions carefully
before you start assembling, follow each assembly step exactly as described and keep to the correct sequence
of assembly as instructed.
Assembly of the training device must be carried out thoroughly by an adult person only.
Assemble the training device in a location which is level, clean and clear of obstructions. 2 people are required
to carry out the assembly.
Please be aware a possible risk of injury at the time of assembly and at each time of using this device exists.
For this reason, always be careful and thorough in your actions when assembling this device.
Make sure that the parts necessary for each stage of assembly are only hand tightened together and only tight-
en parts completely when all parts have been fitted together perfectly.
Training can only start when the training device has been fully assembled.
ATTENTION: All the screws, washers and nuts required for the assembly of this training device come
pre-assembled. Please loosen these fixing materials before each assembly step and then follow each
step as indicated in the diagrams and then tighten the fixing material back up again.
Assembly Step 1.1:
Connect the right and left side stabilisers (4) to the main tube, fixed (1). For this use two screw sets (3). Then fix
foot plate (2) to the front end of the main tube, fixed (1) using two screw sets (3).
Caution:
Please only tighten the screws hand tight until all components have been assembled correctly. Only after this
should the screws be tightened firmly.
Assembly