5
4.1 Connecting the electrical supply
All Maxx Air models require regular 3 prongs, ground with 120 volt power supply. Plug electrical cord into receptacle. If
using an extension cord be sure it is rated for at least 20 amps for the distance your cord is running. To be safe – make sure
no other equipment is plugged into the same circuit. The Maxx Air should run smoothly on 20 amp, 120 volt, and 60 Hz
circuit.
4.2 Connecting the water supply
Connect standard water hose to female fitting on the right side of your Maxx Air (looking at the fan blade side). If your
water pressure is above 60 pounds per square inch (p.s.i). you must use a pressure regulator (which can be found at your
local hardware store).
Note:
Do not connect to water source exceeding 60 p.s.i. – this can cause damage to your Maxx Air.
5.0 Operating procedures
Back your Maxx Air unit up to a fresh air source such
as an open door or window so the unit can pull in
fresh air from the outside. Next, make sure you have
a natural exhaust at the opposite end of the room, bay
or building such as a window, door or bay door. This
will ensure maximum efficiency from your unit.
Finally make sure there are no obstructions between
your Maxx Air and the people / area you need to
cool.
5.1 Filling the units reservoir with water
Once your water hose is connected – open the water flow
valve (located on the front of your unit) only one and quarter (1 1/4) turns.
This water flow valve adjusts the amount of water
to the unit.
Next, turn water on and fill the reservoir with water. Listen carefully. You can hear water filling the reservoir.
Check your water connection – make sure there is no dripping. Once the reservoir is filled with water the float valve will
automatically shut off the water source. When you no longer
hear the water running – you know that the float valve is fully operational
(the water turns off automatically) and you are now ready to turn on the water pump.
Warning! Do not run water pump without water in the reservoir.
5.2 Turn-on pump
To turn-on the water pump - flip the toggle switch for the water pump to on. Switch is
located on front side of unit.
Warning! Do not run water pump without water in the
reservoir
. The water pump will now begin pumping water to the top of the unit so that
gravity will allow the water to run down the backside of unit inside and on the cooling
pads. (If the water is dripping off of the pads on to the floor – turn your fan on low –
Top: Water control valve
–
controls water to
units water reservoir. Open 1 ¼ turns.
Bottom: Water hook-up for cleaning and
flushing water reservoir.
NOTE: EXTENDED COOLING ZONE: 40’ TO 50’ FROM MAXX AIR
UNIT. AIR MOVEMENT INCLUDES WARM AIR MIXING WITH COOLED
AIR.
