16
IMPORTANT
Tighten the nuts progressively and evenly.
DO NOT USE POWER
10. Lightly grease shaft item 27, using Shell Alvania R2, Castrol AP2 or equivalent
grease.
Holding the gearbox assembly, feed the shaft through the deckplate from below
and locate the spacer tube item 15 (refer to drawings P12427) on the spigot of the
deckplate item 14. Rotate the gearbox assembly to the most appropriate of the
four positions available.
Replace four bolts and spring washers items 15 and 16 removed in step 6 above.
Tighten bolts evenly and firmly - DON’T USE POWER TOOLS.
11. Ensure parts removed in step 5 above are clean along with the top area of the
deckplate.
12. Use grease (specified in step 10 above) and with the aid of a clean brush or non-
fluffy
rag,
lightly grease the thread
on the top end of shaft item 27 and
the bores
and clutch faces of the parts removed
in step 5 above, reassemble them as you
go in reverse order.
IMPORTANT - care must be taken to ensure that the key/keys, item 29 are
properly seated in shaft.
IMPORTANT NOTE TO BOAT BUILDERS
After completing installation we suggest that you spray the top works of the winch with
CRC3097 “Long Life”.
Also protect the winch by wrapping with plastic film and tape.
Experience has shown that on long ocean deliveries as deck cargo sulphur from the
ship’s exhausts settles and severely damages the chrome plating and stainless steel by
breaking down the chrome oxide protective film.
PLEASE LET YOUR CUSTOMER RECEIVE THE WINDLASS FROM YOU IN THE
SAME TOP QUALITY CONDITION THAT YOU RECEIVED IT FROM US
.
