11
ENGLISH
Small brush (23)
The brush is intended for collecting of dust from
furniture surface, pile prevents the damage of
polished furniture surface.
Crevice nozzle (24)
The attachment is intended for cleaning of
radiators, chinks, corners ans spaces between
cushions.
Instruction manual
•
Before using the unit unwind the power cord
to the required length and insert the plug into
the socket.
•
Do not unwind the power cord further than
the red mark.
Attention!
Always switch on the unit with the installed
dust container (19) filled with water and with
filtration block (20), outlet HEPA filter (21),
inlet and outlet foam rubber filters installed.
Always make sure that the filters are properly
installed.
•
To switch on the vacuum cleaner press the
On/Off button (6).
•
During the operation you can control the suc-
tion power using the electronic power control
(5) (pic. 12) or the automatic control (11) on
the handle of the flexible hose (12) (pic. 13).
•
After room cleaning switch off the unit and
take the plug out of the socket.
•
To wind the cord press the button (1), hold
the winding cord with hand in order to avoid
its whipping and damage (pic. 17).
•
Between operations use the brush storage
space (16).
•
Use the handle (2) for carrying the vacuum
cleaner.
Blow off function
•
Insert the flexible hose ending (8) into the air
inlet (4).
•
Insert the hose according to the guideline
until fixation (click) (pic. 18)
•
During the operation you can control the suc-
tion power using the electronic power control
(5) (pic. 12) or the automatic control (11) on
the handle of the flexible hose (12) (pic. 13).
Note: before using this function make sure
that there is no water in the dust container.
Vacuum cleaner maintenance during its
operation
Change water as it becomes dirty during the unit
operation. This procedure is described in the
chapter “Filling the dust container with water”. In
case of suction power decrease clean the filters.
This procedure is described in the chapter
“Vacuum cleaner care”.
Note: Pour dirty water out of the container
and wash the dust container after every use
of the vacuum cleaner.
•
Before removing the dust container switch
off the vacuum cleaner by pressing the but-
ton (6), then take the plug out of the socket.
Vacuum cleaner care
Cleaning the filtration block(20)
•
Open the lid (3) pulling its edge (pic. 1).
•
Remove the filtration block (20) by taking
the ledge on the block and pulling it upwards
(pic. 2).
•
Remove the container (19) and pour dirty
water out of the container.
•
Remove the foam filter (25), having prelimi-
nary removed the lid of the filter (pic. 15).
•
Remove the air nozzle pulling it downwards.
•
Wash the air nozzle and the foam filter (25)
under slightly warm water jet, dry them thor-
oughly and install back in their places.
•
Wash and dry the container (19).
Note: Provide that rubber sealing gasket is
clean and there is no dust accumulated on
it, as in case of dirt accumulation the suction
power can decrease (pic. 19).
•
Insert the filtration block (20) into the con-
tainer (19) (pic. 4).
•
Set the container into the body of the vacu-
um cleaner and make sure that the container
(19) and the filtration block (20) are installed
properly.
•
Close the lid (3) having matched the ledges
on the lid with the grooves on the body of the
vacuum cleaner, then press the lid for fixa-
tion (pic. 5.6).
mw-3250.indd 11
31.01.2013 15:27:41
