Maxwell MW-2113 BK, Manual Instruction

Page: 12 / 32

12
ENGLISH
•
Constantly check the power cord,
prevent it from multiple twisting,
regularly switch the unit off and
straighten the power cord.
•
Seat a person so that his/her head
is approximately at your eye level,
cover the person’s shoulders with
a towel and set hair with the comb.
Reminder
–
Always cut off a little amount of
hair at a time; if necessary you can
always return to the cut off part and
trim off additional hair.
–
The best haircutting results are
reached on dry hair, not wet.
–
Comb the hair to reveal uneven locks.
–
It is better to leave longer hair after
cutting for the first time.
–
After learning your clipper better,
you will be able to arrange your hair
in any style you need.
Attachment combs
The length of hair depends on the
attachment comb:
–
attachment comb (5): length of hair
left 3 mm
–
attachment comb (6): length of hair
left 6 mm
–
attachment comb (7): length of hair
left 9 mm
–
attachment comb (8): length of hair
left 12 mm
Install the selected attachment comb
on the blades (2, 3), teeth up, and press
on the ledge in the bottom part of the
attachment until locking (see pic. 9).
Before cutting hair make sure that the
attachment is locked on its installa-
tion place. To remove the attachment
comb press the clamp and remove the
attachment.
Step one
Set the 3 mm attachment comb (5) or
6 mm attachment comb (6). Switch
the unit on using the power switch (1),
setting it to position «
ON ». Hold the
hair clipper with the blades pointed
upwards. Start cutting from the begin-
ning of the hair growth. Slowly move the
trimmer upwards. This way cut the head
back area at neck bottom and near the
ears (pic. 1, 2, 3).
Step two
Switch the hair clipper off with the
power switch (1) by setting it to the
position «
OFF », unplug the unit, then
set the 9 mm attachment comb (7) for
longer hair or 12 mm attachment comb
(8) and continue cutting hair near top of
the head (pic. 4).
Step 3 – cutting in the temples area
Switch the hair clipper off and unplug it,
then set the 3 mm attachment comb (5)
or 6 mm attachment comb (6) and cut
hair in the area of temples. Then set the
9 mm attachment comb (7) or 12 mm
attachment comb (8) and continue cut-
ting towards the top of the head (pic. 3).
Step 4 – cutting the crown
of the head
Using the 9 mm attachment comb (7)
or 12 mm attachment comb (8), cut the
hair on the top of the head towards the
crown against the hair growth direction
(pic. 4).
•
You can cut hair against and along
the direction of hair growth, but
keep in mind that the hair cut
against the growth will be shorter
than the hair cut along the growth.
IM_MW-2113_100 x140.indd 12 13.12.2016 9:24:23