MaxPro MPBDP16, User Manual

Page: 11 / 112

D Drill Press MPBDP16 User Manual
11
(3)Screw the tightening screw (5) back down again.
7. Clamping the workpiece
As a general rule, use a machine vice or another suitable clamping device to lock a workpiece into position.
Never hold the workpiece in place with your hand! When drilling, the workpiece should be able to travel
on the drill table (4) for self-centering purposes. Ensure that the workpiece cannot rotate.
This is best achieved by placing the workpiece/machine vice on a sturdy block.
Important! Sheetmetal parts must be clamped in to prevent them from being torn up. Properly set the
height and angle of the drill table for each workpiece. There must be enough distance between the upper
edge of the workpiece and tip of the drill bit.
8. Adjustment of speeds
The spindle speeds can be adjusted by changing the position of v-belt on the pulley when adjusting, mover
the v-belt to required position after releasing the shifter bar, then fasten the shifter bar again as soon as
the v-belt has been adjusted in proper working condition.
Reference list of Drill, Revolution and Various Materials to be Drilled
Drill Diameter
(mm)
Material
Steel Cast Iron Aluminum Plastics Wood
Rotative speed R. P. M
Ɍϯ 1900 1900 2350 2350 2350
Ɍϰ 1900 1550 1900 2350 2350
Ɍϱ 1550 1000 1550 1900 1900
Ɍϲ 1000 800 1000 1900 1900
Ɍϵ 540 620 800 1550 1550
Ɍϭϯ 450 450 540 1000 1000
Ɍϭϱ 280 450 450 800 800
Ɍϭϲ 280 280 450 620 620
Electric Circuit Diagram
Power supply: AC 220-240V 50Hz single phase
The motor can be turned on or off by switch k.
Note: A socket shall be provided for earth connection when arranging sockets, so tha the case of the
machine can be reliably earthed to avoid electric shock.
GB