MaxPro PROFESSIONAL 114-0100, Manual

Page: 7 / 69

5 GB
5. Descrip ti on for some main technical parameters on the nameplate
No. Mark and legend Meaning descrip ti on
1 Single-phase power supply
2
Output range, rated minimum and ma x imum welding current and its
corresponding load voltage
3 U
0
（
V
）
Rated no-load voltage ( Volts )
4 X Load dura ti on rate symbol
5 I
2
（
A
）
Rated welding current symbol ( Ampere )
6 U
2
（
V
）
Rated load voltage ( Volts )
7 35% 60% 100%, etc. The ra ti o of the given load dura ti on to the full cycle ( 10 min ) ti me
8 I
1
（
A
）
Rated input current
9 U
1
（
V
）
Rated input supply voltage
10 I
le ff
( A ) Ma x imum e ff ec ti ve input current
11 IP21S Degree of protec ti on
Wel d in g c urr ent r an g e (f o r fl at w el d in g) ( A )
Welding current range (for vertical welding and overhead welding)(A)
Diameter mm
2.5 3.2 4.0 4.5 5.0
Ilmenite type 50~85 80~130 120~180 145~200 170~200
Lime ti tania type electrode 50~100 90~130 140~180 160~200 180~200
Basic fl u x
electrode
( reverse polarity )
55~85
100~140 140~190 180~200
Electrode
Diameter mm
2.5 3.2 4.0 4.5 5.0
Ilmenite type 40~70 60~110 100~150 120~180 130~200
Lime ti tania type electrode 50~90 80~130 110~170 125~180 140~210
Basic fl u x electrode
( reverse polarity )
50~80 90~130 120~180 160~210
Electrode
2 Connecting the quick clamp of the welding clamp and the earth clamp to the positive and negative pole
in the right way (Fig.1)
3 Setting and operation of manual welding
Turn on the power switch, and switch the welding machine power to “ON” position (Fig.2), then the
welding machine has output. And then use the “welding current” potentiometer to set the welding
current (Fig.3) to improve the arcing and welding effect.
4 Manual welding conditions
The current values in the table below are for reference only. For detailed welding conditions, please
refer to the welding conditions required by the electrodes of various sizes.
1 � 50/60Hz