15
OPERATING INSTRUCTIONS
Having properly installed and wired your new CB
and connected the antenna, you are now ready to
adjust your radio for optimum reception and voice
transmission.
For proper operation, the radio's microphone must be
connected to the unit. Insert the microphone plug into
the microphone jack (MIC). Push inward and tighten
the plug's locking nut.
NOTE:
If you choose to remove the microphone and
cord for storage, be sure to unscrew the locking nut
then gently pull out the microphone plug to prevent
damage to the microphone cord.
For CB Operation
1. Turn the power on and adjust the volume to the
desired listening level. Set the CB-PA switch to the
CB position, and the CB/ WX mode selector knob to
the CB mode position.
NOTE:
Verify that the CH 9-NOR-CH 19 switch is in
the NOR (normal) position, and the S/RF-SWR-CAL
switch is set to S/RF.
2. Use the CB channel selector knob to select the
desired channel. To use Emergency CH 9 or
Highway CH 19, set the CH 9-NOR-CH 19
switch to the desired position.
3. To reduce undesirable background noise, select a
channel where no signals are present, or wait until
signals cease on your channel. Rotate the squelch
control clockwise until the background noise ceases.
