In4G User Manual
- 63 -
2.
In IP Stack modes:
a.
Open the GUI with an IP connection to the modem and log in.
i.
Check that the settings are correct for the equipment that you are
wanting to connect to, including the serial baud rate etc.
ii.
Check that the signal strength is of a good level, better than -81
dBm.
b.
Use an SNMP viewer to connect to the modem SNMP server.
i.
Check signal strength, good levels are better than -81 dBm.
ii.
Check that the modem settings are correct.
3.
In either mode send an SMS to the modem to perform the following:
a.
Check RSSI: By sending INTELIMAX.PARK.RSSI to the modem the modem
will respond with the RSSI which should be better than -81 dBm.
b.
Check APN and WAN connection using: INTELIMAX.PARK.WANIP. The
response
is:
“IP:<IP.IP.IP.IP>,APN:<APN>,ID:<ID>,PW:<PW>,Auth:<PAP,
C
HAP,BOTH>,Reg:<0,1>,Sig:<CSQ>”
c.
If neither command work then reboot the modem using:
INTELIMAX.PARK.REBOOT
Summary of Contents for Intelimax+4G
