Maxon GPSLR Series, Operation Manual

Page: 30 / 33

30
8. Load the platform at bed
level as follows. Make
sure retention ramps are
in the retention position
(FIG. 30-1) . Then, push
carts out of the vehicle
body to correct position on
the platform. If platform is
equipped with cart dishes,
ensure the rear wheels
of each cart are seated
in the dishes. If standing
on platform with the carts,
stand in the footprint area
shown and comply with
WARNING .
LOADING PLATFORM AT BED LEVEL
(RAMP IN RETENTION POSITION)
FIG. 30-1
Pulling the load from vehicle to platform can result in a fall
from platform and serious injury. When unloading vehicle,
always push the load out on the platform.
WARNING
!
RETENTION
RAMPS
VEHICLE
BODY
9. Lower the platform to ground
level as follows. Hold the
internal control switch in the
DOWN position (FIG. 30-2B)
until platform is sitting on the
ground (FIG. 30-2A) .
FIG. 30-2B
NOTE: If necessary, release the
control switch to stop the
platform from moving.
LOWERING PLATFORM TO GROUND
FIG. 30-2A