5
Install belt clip onto the belt clip holder located on the upper left hand corner of the radio, held as
if looking at the back of the unit. Locate slot location in belt clip and push belt clip until a click is
heard.
To Remove:
Push and hold release button located at top of belt clip and slide clip off the belt clip holder.
Battery Charging and Care
To ensure peak performance from your radio, the battery pack must be fully charged. Proper care
and charging will allow maximum performance and life of your battery pack.
SPC-5000 Desktop Charger provides 2 hours charging to one radio and one battery.
To receive maximum performance from your radio and battery pack, periodically completely
discharge and recharge the battery pack.
Status Indicators and Audible Alert Tones
Your SP-0402 has a sophisticated microprocessor control which provides a series of audible alert
tones.
Upon initial power up, a quick melody indicates that the self-test of the microprocessor functions
has been completed satisfactorily. A series of tones may be sounded with any of the following
conditions:
- Attempt to transmit on a channel set for receive only
- Attempt to transmit on a channel that is already in use when busy channel lockout has
been programmed into the radio *
- Transmitting time has exceeded time-out timer programmed length *
- Low battery condition
- Selecting a channel with no programmed frequency
*
Indicates a function that is initially programmed into the radio by your Maxon Dealer.
NOTE:
All audible tones can be programmed off for silent operation.
Status Decription LED
color
Audible
Tone
Normal
Power On - Ready
N/A Melody
Call Received
Orange
N/A
Correct Call
Green
N/A
Busy Channel
Orange
N/A
Transmit Red
N/A
Transmit not allowed
Red Flashing
Two beeps
Scanning
Normal Scan mode
Green Flashing
N/A
Warning
Low Battery
Red Flashing
2 beeps repeated
Busy Channel lockout
orange
2 beep repeated
TX Inhibit
N/A
Two beeps
Time-out-timer N/A
Single beep/3 beeps
repeated
Error
Unlock N/A Two
beeps
