BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING
Risk of fire or electric shock.
Luminaire wiring and electrical parts may be damaged when drilling for
installation of led retrofit kit, check for enclosed wiring and components.
To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
General Safety Information
• To reduce the risk of death, personal injury or property damage from fire, electric shock, falling parts, cuts/abrasions,
and other hazards read all warnings and instructions included with and on the fixture box and all fixture labels.
• Before installing, servicing, or performing routine maintenance upon this equipment, follow these general precautions.
• Commercial installation, service and maintenance of luminaires should be performed by a qualified licensed electrician.
• For Residential installation: If you are unsure about the installation or maintenance of the luminaires,
consult a qualified licensed electrician and check your local electrical code.
• DO NOT INSTALL DAMAGED PRODUCT!
• This fixture is intended to be connected to a properly installed and grounded UL listed junction box.
WARNING:
RISK OF ELECTRICAL SHOCK
• Turn off the power when you perform any maintenance.
• Verify that supply voltage is correct by comparing it with the luminaire label information.
• Make all electrical and grounded connections in accordance with the National Electrical Code and
any applicable local code requirements.
• All wiring connections should be capped with UL approved wire connectors.
CAUTION:
RISK OF INJURY
• Wear gloves and safety glasses at all times when removing luminaire from carton, installing, servicing or performing maintenance.
• Avoid direct eye exposure to the light source while it is on.
• Account for small parts and destroy packing material, as these may be hazardous to children.
CAUTION:
RISK OF FIRE
• Keep combustible and other materials that can burn away from luminaire and lamp/lens.
• MIN 90°C SUPPLY CONDUCTORS
• NOT FOR USE IN DWELLINGS
• Suitable for Wet Locations
Operating temperature: -40°C to 50°C
Illustrations in the manual are for installation purposes only. It may not be identical to the fixture purchased.
Models:
QMP-XXXYZZ-&##$%%%
Where:
XXX = can be 50, 100, 150, 200, 250, 300 for wattage
Y = can be any format U=120V/277V, H = 347/480V or any alphabetical format for input voltage.
ZZ = can be any alphabetical format for distribution.
& = can be blank or number for CRI
## = can be 40, 50 for CCT
$ = can be any alphabetical format for color finish
%%% = can be blank, MS(Motion sensor), PC or any alphanumeric for sensor
© Copyright 2017. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: [email protected]
