SAVE THESE INSTRUCTIONS.
WATER INGRESS PROTECTION:
STAR is rated to a standard IP55 enabling it to be mounted outdoors and exposed to occasional rainfall. To prolong
the life of the heater we recommend installing it where it will be sheltered from the effects of weather. The
heater is not intended for installation in locations that are permanently wet or humid.
Installation in potentially wet or humid rooms such as bathrooms must be carried out by a suitably qualified
installer and comply with local electrical safety requirements. Installation must be such that:
the heater must not be able to become detached from the fittings and fall into a bathtub, shower,
swimming pool or other water container;
Switches and other controls cannot be touched by a person in a bath or shower.
If in doubt, do not install. AUSWAY PACIFIC PTY LTD shall not be liable for any loss, damage or injury caused
or resulting from inadequate fitting or incorrect placement of heaters close to water sources.
ELECTRICAL INFORMATION:
Installation must only be carried out by competent persons or a qualified electrician according to national
regulations.
Table 1. Electrical Specification
Model
Rated Power
Voltage
Current
Frequency
Fuse (Minimum)
STAR 2000
2000W
220-
240V
8.7A
50/60Hz
13A
STAR 2500
2500W
220-
240V
10.9A
50/60Hz
13A
STAR 3000
3000W
220-
240V
13A
50/60Hz
13A
Summary of Contents for STAR 2000
Page 5: ...INSTALLATION Diagram 2 Correct Wall Ceiling Position...
Page 8: ......
