negotiation
result,
the
indicator
situation
specification is as the indicator specification
described above. If the LED Indicators don
’
t light
after the connected, then you need to check if the
other Network device and network cable are
connected normally.
3. Appendix
◆RJ-45 PIN SPECIFICATION
When the TEG1005/1008 work as 1000Mbps
work mode, you will need to use all the 4 Pairs pin
of the Cat5/Cat5e cable. Please match the Pin
Pairs correctly; the following are the definition of
the standard RJ-45 socket and connector:
1 2 3 4 5 6 7
Figure 3.1 the standard RJ-45 Socket/connector
RJ-45 Connector pin definition
Pin S/N
.
Signature
1
A_TX + (sender )
2
A_TX - (sender )
3
B_RX + (receiver)
4
C_TX + (sender )
5
C_TX - (sender )
6
B_RX - (receiver)
7
D_RX + (receiver)
8
D_RX - (receiver)
◆Parallel and crossing cable
TEG1005/1008 has auto MDI/MDI-X function, it
can distinguishes the parallel and crossing cable
automatically when you connect the switch to
other device ; Meantime TEG1005/1008 transfer
automatically to make sure the fast connectivity
and communication ( From TD sending change to
RD receiving , or From RD receiving to TD
sending )
6
