7
English
LED/buttons
*1 : The “Power“ LED indicator will blink in standby mode. It will get into standby
mode, if you plug the device to outlet and no Ethernet link detected after booted
and 60 second later. If you unplug the Ethernet cable, it will get into standby mode
after 60 seconds.
Under standby mode, PLC and ETH LEDs will both be off.
Push Buttons
(Only applicable for models with push button)
Push button functions are disabled under Standby mode.
Setup Button Usage:
First time to setup your private network:
Step 1.
Press and hold the device’s “SETUP” button for more than 10 seconds. You can re-
lease the button when you see all the device’s LEDs are off and restart. The original
network encryption setting is cleared.
Step 2.
Repeat Step 1 to clear another device’s original network encryption setting.
Step 3.
Press both devices’ “SETUP” button for 1 to 3 seconds. You will see both devices’
“Power” LED start blinking. Both devices start to communicate and try to setup their
private network encryption. They will complete the new private network encryption
setting within 10 seconds. You will see both devices’ all LEDs are off and restart.
Note:
The setup operation timeout is 120 seconds.
PWR
(Red)
On: Power on
Blinking: Standby mode (*1)
PLC
(Green/Orange/Red)
ETH
(Green)
On: Ethernet Link detected
