DANGER!
Potential hazard that will result in serious injury or
loss of life.
•
•
23
22
model no. 058-9345-0 | contact us 1-888-670-6682
Maintenance
Lubrication:
If the Air-powered Clipped-head Framing Nailer and the
compressor are not equipped with an in-line lubrication system, place up
to 6 drops of pneumatic tool oil into the air inlet before each work day or
after every 2 hours of continuous use, depending on the characteristics of
the workpiece and type of nails used.
Disconnect the tool from the air compressor before
performing maintenance/service, adjusting, clearing jams,
reloading, and when it is not in use.
Repairs must be performed by a qualified service technician
only. Failure to comply will lead to serious injury or loss of life.
•
Note:
When temperatures are below freezing, maintain the tools
in a warm condition using any safe, convenient method.
•
•
•
•
Air-operated tools must be inspected periodically and worn or broken
parts must be replaced in order to keep tools operating safely and
efficiently.
Inspect and replace worn or damaged O-rings, seals, etc. Tighten all
screws and caps frequently in order to help prevent personal injury.
Inspect the trigger, spring, and safety mechanism for free movement on a
regular basis in order to ensure that the safety system is fully functional.
Verify that no parts are loose or missing and no parts are sticking or
jammed.
Keep the magazine of the tool clean and free of any dirt or abrasive
particles.
TM
MAINTENANCE
REQUIRED
DESCRIPTION
TOOLS OR
MATERIALS
REQUIRED
MAXIMUM SERVICE INTERVAL
Each use or
every 2 hrs
Monthly
As
needed
General
inspection–
free movement
In-depth
inspection
Replace worn or
broken parts
Lubrication
Trigger, spring,
safety
mechanism
Worn or broken
parts
See below
None
Pneumatic
tool oil
X
X
X
X
X
