model no. 054-3245-2 | contact us 1-888-670-6682
14
15
TM
VARIABLE SPEED
The variable speed trigger switch delivers higher speed with
increased trigger pressure and lower speed with decreased
trigger pressure.
FORWARD AND REVERSE
The direction of bit rotation is reversible and is controlled by a
selector located above the trigger switch. (Fig. D)
With the impact wrench held in normal operating positions:
• Position the forward/reverse selector to the left of the tool
for forward.
• Position the forward/reverse selector to the right of the
tool for reverse.
• Position the forward/reverse selector in the centre will
lock the switch trigger to help reduce the possibility of
accidental starting when not in use.
INSTALLING AND REMOVING A SOCKET
Always use the correct size socket for bolts and nuts. An
incorrect size socket will result in inaccurate and inconsistent
fastening torque and/or damage to the bolt or nut.
To install the socket, push it onto the anvil of the tool until it
locks into place. (Fig. E) To remove the socket, simply pull it
off.
OPER
A
TING INS
TRUCTIONS
LED WORKLIGHT
When the unit is switched on, the LED worklight also comes on to
ensure better vision and to make working in dark areas safer. LED
work light remains on for 15 seconds after the trigger switch is
released.
REMAINING POWER INDICATOR
If the trigger switch is pressed, the remaining power indicator lights
for 5 seconds and the battery’s remaining power can be checked.
LED INDICATOR
REMAINING POWER STATUS
1
0–25 %
2
25–50 %
3
50–75 %
4
75–100 %
BELT HOOK
The belt hook is used to hang the tool from your waist belt
while working. Install the belt hook securely in the groove of
the drill and tighten the screw to fix the hook firmly. (Fig. F)
TEMPERATURE CUT OUT
When used as intended, the driver cannot be subject to
overload. But running continuously at full load for a long
time will cause the battery pack to overheat. If the allowable
battery temperature range of 32–158°F (0–70°C) is exceeded,
the battery pack will automatically stop operating and will not
restart until it has cooled to a safe level.
OPER
A
TING
INS
TRUCTIONS
CAUTION!
To prevent gear damage, always allow the chuck to come to a
complete stop before changing the direction of rotation.
CAUTION!
• When using the belt hook, hang the power tool firmly so as
not to drop it accidentally. If the power tool is dropped, it
may lead to an accident.
• When carrying the tool hooked to your waist belt, do not
fit any bit to the top of the power tool, as this may lead to
accidental injury.
WARNING!
Do not insert or remove socket while the tool is activated. Make
sure the battery pack is removed or the forward & reverse lever is
in the centre locking position when inserting or removing socket.
NOTE:
This tool is equipped with an electric brake. When the brake
is functioning properly, sparks may be visible through the vent slots
in the housing. This is normal and is the action of the brake.
NOTE:
The impact wrench will not run unless the direction of
forward/reverse selector is engaged fully to the left or right.
Summary of Contents for 054-3245-2
Page 1: ......
