P9
Max-555
OPERATION
Switch ON the transceiver by turning the Power switch / Volume control
clockwise.
A beep sounds
Adjust the volume by pressing and holding the Monitor key, then rotating
the Power switch / Volume control.
Rotate the Channel selector to select your desired channel.
When you receive an appropriate signal, you will hear audio from the
speaker.
To make a call, press and hold the PTT switch, then speak into the
microphone using your normal speaking voice.
Hold the microphone approximately 1.5 inches (3 to 4 cm) from your lips.
Release the PTT switch to receive.
Note:
When the battery pack voltage becomes too low, transmission will stop
and the LED will blink red. See "Low Battery Warning" on page 10.
