Spangenberg International B.V. – Rendementsweg 24P – 3641 SL Mijdrecht – Holland – T. +31 (0) 297 253969 – F. +31 (0) 297 256445
–
www.spangenberg.nl
•
Do not try to repair the appliance yourself. This could give rise to life-threatening
situations.
•
Make sure the cord does not come in contact with sharp or hot objects and keep it away
from open fire. To pull the plug out of the socket, always pull on the plug and not on the
cord.
•
Make sure that no one can accidentally pull the cord loose or trip over the cord.
•
Always keep an eye on the appliance when in use.
•
Never let children use appliances without supervision.
•
Always pull the plug out of the socket when the appliance is not being used and always
before cleaning.
•
Warning! As long as the plug is in the socket the appliance is connected to the power
source.
•
Turn off the appliance before pulling the plug out of the socket.
•
Never carry the appliance by the cord.
•
Do not use any extra devices that are not supplied along with the appliance.
•
Turn off the appliance after use by removing the plug from the socket.
•
The electrical installation must satisfy the applicable national and local regulations.
Preparations before using for the first time
•
Check to make sure the appliance is undamaged. In case of any damage, contact your
supplier immediately and do NOT use the appliance.
•
Remove all the packing material.
•
Place the legs underneath the fryer (MF52 and MF76)
•
Place the appliance in the middle of a steady place and level the appliance.
•
Make sure the appliance is not placed next to any sources that radiate heat (for example
a heater, stove or oven).
•
Make sure the appliance is placed 10 cm from every other object or walls.
•
Position the appliance in such a way that the plug is accessible at all times.
•
Clean the appliance with luke-warm water and a soft cloth.
•
Place the inner case in the appliance. (MF 1 x 4L and MF 2 x 4L)
•
Place the heating element in the inner case and lower the control panel at the back of the
appliance. (MF 1 x 4L and MF 2 x 4L)
•
Place the grid over the heating element and make certain that the grid is being supported
by the bottom and not resting on the heating element.
