Spangenberg International B.V.
– Nijverheidsweg 19F – 3641 RP Mijdrecht – Holland – T. +31 (0) 297 253 969 – F. +31 (0) 297 256 445
Troubleshooting
The follow overview will help you understand possible problems. However, only qualified
technicians should attempt to open or repair the machine. Contact your supplier when in doubt.
Problem
Possible Cause
Possible Solution
The appliance does not work
(diplay off).
▪
The appliance is switched off.
▪
The power supply is
interupted.
▪
The voltage is not correct.
➢
Switch on the appliance.
➢
Check the power supply, plug
in power cable.
➢
Use a compatible power
source.
The appliance does not get warm.
▪
Wrong temperature settings.
▪
Appliance defective.
➢
Change settings.
➢
Contact supplier.
E01
▪
Appliance too hot /
insufficient ventilation.
▪
Appliance near another heat
source.
➢
Make sure the air vents are
unblocked.
➢
Relocate appliance or other
heat source.
➢
Let the appliance cool down,
reset limiter and restart.
E02
▪
Overheated
▪
Sensor damaged/dirty.
➢
Let it cool down, reset limiter
and restart.
➢
Replace/clean sensor.
E03
▪
Voltage too high (>265V)
➢
Use a compatible power
source (check rating label).
E04
▪
Voltage too low (<135V)
➢
Use a compatible power
source (check rating label).
E05
▪
Oil temperature sensor
defect.
➢
Contact supplier.
E06
▪
Heating elemement (sensor)
short circuit.
➢
Contact supplier.
E07
▪
Heating elemement (sensor)
open circuit.
➢
Contact supplier.
E08
▪
Heating elemement (sensor)
overheated.
➢
Contact supplier.