Spangenberg International B.V.
– Nijverheidsweg 19F – 3641 RP Mijdrecht – Holland – T. +31 (0) 297 253 969 – F. +31 (0) 297 256 445
•
Do not use any extra devices or accessories that are not supplied along with the machine.
•
Never put your hands or other body parts near the moving parts of the machine while operational.
•
Always keep an eye on the machine when in use.
•
Keep all packaging away from children and dispose of packaging in accordance with local, state and national
regulations.
•
Avoid overloading the machine.
•
The electrical installation must satisfy the applicable local, state and national regulations.
•
Switch off the machine before pulling the power plug out of the socket.
•
Always disconnect te power supply when the machine is not in use. To pull the plug out of the socket,
always pull on the plug and not on the cable.
•
Do not touch the power plug with wet or damp hands.
•
Keep the power cable away from operating range and do not cover the cable.
•
Make sure the power cable does not come in contact with sharp or hot objects and keep away from open
fire.
•
ATTENTION! As long as the power plug is in the electrical socket the machine is connected to the electric
grid.
Product Specific Safety Regulations
•
This machine may only be used for its intended purpose: Sealing predetermined trays and containers.
•
WARNING! Heated pressure plate (sealing plate) will become hot, handle with care.
First Time Use
•
Unpack and inspect your machine immediately after receipt. If there are any latent defects or damage to
the machine then immediately contact your supplier. Save all packaging materials in case the machine
needs to be returned or inspected by the freight carrier.
•
Remove any protective film from all surfaces (if applicable).
•
Read this instruction manual completely before attempting to install and operate this product. When in
doubt, contact your supplier.
•
If your machine is supplied with a factory fitted molded plug then you may plug the unit into a standard
electrical outlet. Make sure that the voltage of the machine and the wall outlet are compatible. If your
machine is not supplied with a factory fitted molded plug then a qualified electrical engineer must be
contracted to wire the unit to the power supply.
•
Before using the appliance for the first time, it is recommended to clean the appliance according to
instructions
(see chapter “
Cleaning and Maintenance
”
).
