Spangenberg International B.V.
– Nijverheidsweg 19F – 3641 RP Mijdrecht – Holland – T. +31 (0) 297 253 969 – F. +31 (0) 297 256 445
•
Do not use the machine after it has fallen or is damaged in any other way. Have it checked and repaired by a
certified engineer.
•
WARNING! Do not try to repair the machine yourself. This may cause life-threatening situations.
•
Make sure the power cable does not come in contact with sharp or hot objects and keep it away from open
fire. To pull the plug out of the socket, always pull on the plug and not on the cable.
•
Keep the power cable away from operating range. Do not lay over carpets or heat insulation an do not cover
the cable.
•
Always keep an eye on the machine when in use.
•
Never put your hands near the moving parts of the machine.
•
Always pull the power plug out of the socket when the machine is not being used.
•
ATTENTION! As long as the power plug is in the socket the machine is connected to the power source.
•
Keep all packaging away from children. Dispose of packaging in accordance to the regulations of local
authorities.
•
Turn off the machine before pulling the power plug out of the socket.
•
Never try to move or carry the machine by the power cord.
•
Do not use any extra devices that are not supplied along with the machine.
•
Avoid overloading the machine.
•
Do not place the machine on its side or upside-down. Also while the appliance is being transported.
•
The electrical installation must satisfy the applicable national and local regulations.
First Time Use
•
Unpack and inspect your machine immediately after receipt. If there are any latent defects or damage to
the machine then immediately contact your dealer. Save all packaging materials in case the machine needs
to be returned or for inspection by the freight carrier.
•
Remove any protective film from all surfaces.
•
Read this instruction manual completely before attempting to install and operate this product. All
installations and set ups must be done by authorized service agents, your dealer, or Maxima
representatives.
•
If your machine is supplied with a factory fitted molded plug then you may plug the unit into a standard
electrical outlet. Make sure that the voltage of the machine and the wall outlet are compatible. If your
machine is not supplied with a factory fitted molded plug then a qualified electrical engineer must be
contracted to wire the unit to the power supply.
•
Before using your appliance for the first time it is recommended to clean the appliance according to
instructions mentioned in
chapter “
Cleaning and Maintenance
”
.
