
17
Maxim Integrated
Evaluates: DS34S132
DS34S132 Evaluation Kit
2. Installation
2.1 Introduction
The EV kit is delivered completely assembled and
ready to use. Configure the EV kit using an ASCII
terminal connected to the EV kit control port as
described in
. If problems are encoun-
tered, see
5. Troubleshooting and Diagnostics
test and diagnostics instructions.
2.2 Making Internal Settings
The EV kit contains jumpers and switches that provide
preliminary configuration of the device. It should not
be necessary to change these settings from the factory
default. If it becomes necessary to change them, follow
these instructions:
1) Open the EV kit enclosure.
2) Set jumpers or switches located on the motherboard
or on the daughter card.
3) Close the EV kit enclosure.
2.2.1 Opening the DS34S132 EV Kit Case
Open the EV kit case to gain access.
Caution: The EV
kit contains components sensitive to electrostatic
discharge (ESD). To prevent ESD damage, avoid
touching the internal components. Before moving the
jumpers, touch the EV kit frame.
To open the unit’s case:
1) Disconnect all cables from the EV kit.
2) Unscrew all the cover screws on the top and side
panels of the unit.
3) Remove the top cover by pulling it straight up.
2.2.2 Setting the Internal Jumpers
Internal jumpers are located on the motherboard and the
CPU daughter card. To set the motherboard jumpers:
1) See
Figure 2-1
to locate internal jumpers on the
motherboard PCB.
2) Set the motherboard jumpers while referring to
.
To set the CPU daughter card jumpers:
1) See
Figure 2-2
to locate internal jumpers on the
daughter card.
2) Set the daughter card jumpers referring to
Table 1-2. Technical Specifications
(continued)
Ethernet
Management
Standards
IEEE 802.3, Ethernet, 802.1p
and Q
Data Rate
10/100/1000 half/full duplex
Range
Up to 100m on UTP Cat. 5
Type
10/100/1000BASE-TX half/
full-duplex port with autone-
gotiation support
Connector
8-pin RJ45
Control
Type
Standard DB9 connector
Interface
RS-232/V.24 (DCE) interface
Data Rate
115.2kbps
Data Bits
8
Stop Bit
1
Flow Control
None
Station Clock
Clock Rate
2.048Mbps or 1.544Mbps
Connector
8-pin RJ45
Line
Impedance
120
I
or 100
I
Common
Clock
Standard
LVTTL input (square wave
0/3.3V)
Connector
BNC
Diagnostics
Loopbacks
LLB and RLB
Ethernet Port
Indicators
LINK
Off when line is not con-
nected;
On when line is connected
ACT
Off when no activity;
On when a frame is being
transmitted or received on
the line
E1/T1 Port
Indicators
LOS
On when there is no data
in Rx
LOF
On when loss of frame is
detected
Power
—
100 to 240V AC, 50Hz to
60Hz
Physical
Height
11.1cm (4.375in)
Width
48.3cm (19in)
Depth
34.3cm (13.5in)