OPERATING INSTRUCTIONS
4-1
SECTION 4
OPERATING INSTRUCTIONS
WE 01/WE 05
The WE 01/WE 05 is a powerful and versatile solid state control. Up to 30 programs can be
stored and executed. The computer comes standard with 12 pre – programmed cycles, which are
discussed later in the manual (see table of contents for locations).
NOTE:
Do not
power off the machine while the mode switch is in Program position.
Doing this will result in program data corruption, requiring a reprogramming of
some or all of the cycles. Always move the Program switch into the Run position
before powering down the equipment.
Keypad
The user interface for the WE 01/WE 05 control is a four push button keypad with an LED
(Light Emitting Diode) display. This interface is located on the front of the machine. In Run mode,
the keys function as follows:
Used to stop cycle in progress
Used to start a cycle
Used in cycle selection:
Pressing this key increment the
cycle up by one.
Used in cycle selection:
Pressing this key decrement the
cycle down by one.
Fig. 4-1
Keypad main controller
CYCLE SELECTION
Press the up or down key until the desired cycle number is showing on the display. Press the
keys just hard enough to activate them. Pressing harder will cause undue wear on the keypad. After
you arrive at the desired cycle, ensure the goods are loaded, and the door is closed. Then press Start.
If the doors is not properly closed and locked, the display will read door until the door is properly
closed and locked. After the door is closed, press start button.
Stop
Start
Cycle
Up
Cycle
Down
Summary of Contents for MWHE20
Page 1: ......
Page 12: ...SPECIFICATION COMPONENT IDENTIFICATION 2 3 C B ...
