Page
11
of
13
HOOK UP THE RUDDER/TAILWHEEL PUSHROD:
Install micro servos in the outer holes of the
servo tray in the fuselage using the
mounting hardware that came with your
servos.
Locate the shorter of the two long pushrod
wires. Slide the pushrod through the
preinstalled guide tube on the
right
side of
the fuselage and through the pushrod
connecter on the tailwheel steering arm.
Put the Z bend of the pushrod through the
outer hole of the arm on the right servo.
Center the servo and the rudder, then
tighten the pushrod connecter.
INSTALL THE PLASTIC TAIL FAIRINGS:
Locate the top fairing and check its fit. Trim it if necessary to clear the rudder. You
can use the provided M2x10 self tapping screws to attach it, but we have found that
clear glossy tape is the easiest way.
Slip the bottom fairing over the tailwheel strut and trim the fairing as needed. The
part of the bottom fairing that is beside the elevators should slip under the top fairing.
Again, tape is the easiest way to hold the fairing in place.
Now you can reinstall the tailwheel.
HOOK UP THE ELEVATOR PUSHROD:
Attach an adjustable pushrod connecter to
the outer hole of the remaining control horn.
Use the provided M2x10 machine screws to
attach the horn to the elevator.
Slide the remaining pushrod through the
