EN-14
EN
Turn On/Off
Turning the System ON/OFF
Press the button on the unit or remote
control.
Note:
When turning the system on, the system will
continue in the mode was set last time.
Note:
Be sure to unplug the power cord from the
outlet when the system is not in use for an
extended period of time.
The unit will switch to standby mode when
the audio cables are disconnected or
when you turn off TV/external device after
several minutes.
Adjust Volume Level
Either,
1) Press the VOL +/- button on the remote
control; or
2) Press / button on the unit,
to increase or decrease the volume level.
If the unit is connected to the TV headphone
jack, you can control the Volume Level
using the TV remote control.
If the unit is connected to TV HDMI jack
with CEC(Customer Electronics Control)
function enabled. The sound of the unit can
be controlled by the TV remote control.
Mute Sound
Press the MUTE button on the remote
control to mute. Press this button again or
VOL+/VOL- buttons on the remote control
or / on the unit to resume the sound.
Bass Boost
Press BASS button on the remote control to
turn on the bass. Press this button again to
switch to level 2 or to turn it off.
Select SRS Sound
Press SRS button on the remote control for 3
seconds to select SRS WOW HD effect. Press
this button again to cancel the effect.
Program Smart Remote Control to
Control TV
You can store a total of up to seven of
your most frequently used TV functions in
the TV learning zone of the Smart Remote
Control. This feature enables you to use
only one remote control to operate the
unit together with your TV.
The remote control codes of a TV are stored
in the Smart Remote Control. The available
preset buttons are ON/OFF , FUNCTION
, ENTER, TV VOL+/VOL-, TV CH+/CH-.
NOTE:
During the learning process, the normal
remote control functions are disabled.
1 Place the Smart Remote Control (A)
within a 5mm-50mm distance from the
TV remote control (B), pointer to pointer
as shown above.
2 Press and hold the LEARN button for 2
seconds to activate the learning mode.
A red indicator on the Smart Remote
Control (A) will light up.
3 Press one of the TV learning zone buttons
on the Smart Remote Control (A), the
red indicator flashes.
4 Press the button on the TV remote
control (B) that is to be stored on the
Smart Remote Control (A). When the
code is received successfully, the red
indicator will quickly flash for 3 times, If
the code is not successfully received,
the red indicator will keep on flashing.
5 Repeat steps 3-4 to program more
functions onto the Smart Remote Control
(A).
6 Press the LEARN button to save the
setting and to exit the learning mode.
Red indicator will turn off immediately.
Basic Operation
