7
Note
This device meets the EN 55022 and EN 61000--2 standards for interference emissions,
the EN 55024 standard for interference, and the EN 60950 electrical safety standard. Any
change made to this device without approval by the manufacturer voids any guarantee of
meeting these standards. In order to assure EMC compliance (electromagnetic compat-
ibility), please follow the corresponding guidelines in this manual.
User note
This device was carefully designed and tested to prevent radio interference. However, you
should note the following for external data cables: If you need to replace any of the data
cables specified by the manufacturer, be sure that the replacement cables have the same
shielding specifications as the original cable to prevent interference. Always use shielded
power lines and only use external devices that are CE certified.
No guarantee for meeting these standards can be maintained if you do not conform to the
above guidelines.
Laser (safety information)
Caution!
Laser radiation when the cover is open!
This laser radiation is contained in the optical drives. When dismantling and/or opening this
drive, be careful:
• not to look into the beam, not even with optical instruments
• not to expose yourself to the beam
• to avoid eyes or skin being exposed to direct or scattered beam.
Failure to observe these guidelines can in the worst case lead to permanent blindness.
The built-in optical drives contain no user-serviceable or reparable parts. Optical drives are
to be repaired solely by the manufacturer. Laser products of laser classes 1 to B may be
used in the product. When the housing is unopened the device meets the requirements of
laser class 1. By opening the device, laser devices up to laser class B may be accessible.
The built-in optical drives contain no user-serviceable or reparable parts. Optical drives are
to be repaired by authorized technicians.
