31
MAXDATA Fusion 6000
Installation Precautions
When you install and test the system board, observe all warnings and cautions in the
installation instructions. To avoid injury, be careful of:
• Sharp pins on connectors
• Sharp pins on printed circuit assemblies
• Rough edges and sharp corners on the chassis
• Hot components (like processors, voltage regulators, and heat sinks)
• Damage to wires that could cause a short circuit
Observe all warnings and cautions that instruct you to refer computer servicing to qualified
technical personnel.
Installation Requirements
CAUTION
Follow these guidelines to meet safety and regulatory requirements when installing this
board assembly.
Read and adhere to all of these instructions and the instructions supplied with the chassis and
associated modules. If the instructions for the chassis are inconsistent with these instructions
or the instructions for associated modules, contact the supplier’s technical support to fi nd
out how you can ensure that your computer meets safety and regulatory requirements. If
you do not follow these instructions and the instructions provided by chassis and module
suppliers, you increase safety risk and the possibility of noncompliance with regional laws
and regulations.
Prevent Power Supply Overload
Do not overload the power supply output. To avoid overloading the power supply, make sure
that the calculated total current loads of all the modules within the computer is less than
the output current rating of each of the power supplies output circuits.
Place Battery Marking
There is insuffi cient space on this system board to provide instructions for replacing and
disposing of the battery. For system safety certifi cation, the following statement or equivalent
statement may be required to be placed permanently and legibly on the chassis near the
battery.
Risk of explosion if battery is incorrectly replaced.
Replace with only the same or equivalent type recommended by the manufacturer. Dispose
of used batteries according to the manufacturer’s instructions.
Use Only for Intended Applications
This system was evaluated as Information Technology Equipment (I.T.E.) for use in computers
that will be installed in offi ces, homes, schools, computer rooms, and similar locations. The
suitability of this product for other applications or environments, (such as medical, industrial,
alarm systems, test equipment, etc.) may require further evaluation.
Summary of Contents for FUSION 6000 I
Page 1: ...1 MAXDATA Fusion 6000 System Manual MAXDATA Fusion 6000...
Page 2: ...2 Inhalt...
Page 6: ...6 Contents...
