Disassembly and Reassembly
11
111707 Service Manual
DISASSEMBL
Y
AND
REASSEMBL
Y
3. Disassembly and Reassembly
The section of the service manual describes the disassembly and reassembly procedure for
the Belinea 101725 Monitor.
WARNING : This has to be disassembled and reassembled carefully because TFT-LCD Panel
is weak for impact. This monitor contains electrostatically sensitive devices.
Use caution when handling these components.
3-1 Disassembly
Cautions : 1. Disconnected the monitor from the power source before disassembly.
2. Follow these directions carefully; never use metal instruments to pry apart the cabinet.
3-1-1 Separation between display part and stand part
1. Diconnect Power Cord and Signal Cable.
2. Remove the 4 screws on the stand.
3. Pry it off the back stand of the monitor.
3-1-2 The Display part Disassembly
The Rear housing Removal
1. Remove the 2 screws on the rear corner of the Rear Cover.
2. Remove Rear Cover from the Front Cover.
3. Remove 2 screws on the Rear Shield Cover and remove it.
4. Disconnect Combo harness and LVDS harness.
5. Remove 4 screws on the Main PCB.
6. Remove 1 screws on the F.G cable of Combo Board.
7. Remove 4 screws on the Combo Board Assembly and then remove it.
8. Remove I/O Shield.
9. Disconnect Key harness on the Main Board.
10. Remove the LVDS harness on the Panel.
11. Remove 2 screws on the Main chassis.
12. Remove Front Cover.
13. Remove 4 screws on the Side of Panel.
14. Remove the Main chassis.
