Instruction for Use
Maintenance Guideline and Instruction
P.34
P.35
7.Information Code: Er 12, electric motor short circuit
7.1Check whether there is any foreign bodies at the output end of the controller
causing short circuit
7.2 Check or replace the motor
8.Some or all of the buttons are not working well
8.1 Uncover the upper case of the electric meter and test if the buttons work
well
8.2 Check or replace the electric meter board
8.3 Disconnect power supply, re-plug and then check if the buttons work well
9.No display on console
9.1 Check if the voltage on the power is normal: AC 220-240V
9.2 Check if the switch is on
9.3 Check if the fuse of plug socket is damaged. Replace if so.
9.4 Check controller and the LED
9.5 Check all connecting cable
9.6 Check or replace the electric meter board
9.7 Check or replace the near motor controller circuit board
1. Guideline
WARNING: Be sure that the motorized treadmill is not plugged in when
you clean or maintain the product.
Cleaning: A comprehensive cleaning shall significantly extend the
product life.
Remove dust regularly to keep parts clean. It is necessary to clean the
exposed parts on two sides out of the belt, and this shall decrease dust
accumulation under the belt. Be sure your sports shoes are clean before
exercise and this could avoid lint from dropping into the running machine and
then damaging the running plate and belt. Scrub the belt surface by a wet cloth
with soap, and be careful not to spill water on the electrical components or
under the belt.
WARNING: Be sure that the motorized treadmill is not plugged in before
remove the motor cover.
It is necessary to clean the motor and lubricate with silicone oil at least
once a year.
The treadmill has been pre-coated with silicone oil between the running plate
and belt. It is necessary to lubricate it by silicone oil regularly, because the
friction between the running belt and plate has big impact on product life and
performance. We recommend you to take regular inspection on the running
plate. If the running plate is damaged, please contact our customer service
center.
We recommend the user to squeeze drops of the silicone oil between running
belt and plate according to the following timetable:
Low frequency users (use time: less than 3 hours per week): add silicone oil
once every 6 months
Middle frequency users (use time: 3-5 hours per week): add silicone oil once
every 3 months
High frequency users (use time: more than 5 hours per week): add silicone oil
once every 1.5 months
We recommend you buy silicone oil from your local distributor or contact us
directly.
2. Instruction
In order to maintain your running machine better to extend product life, it is
recommended to turn off the running machine after using it for 2 hours, and
have a 10 min break before continue.
If the running belt is too loose, it could be slippery when you exercise; if too
tight, it may decrease the motor performance and increase the abrasion of
drum and running belt. You can check whether the running belt is fitting or not
by raising the two sides of running belt horizontally by hands. The suitable
distance between raised running belt and plate is 50-75mm.
2.1Running plate lubrication
1. We mentioned above that it is necessary to add silicone oil on running plate
at the right time. But please do not use excessive silicone oil. Remember:
proper lubrication is an important factor in extending the product life of a
treadmill.
2. The method to check whether it is necessary to add silicone oil
Raise the running belt and stretch your hand as far as possible to touch the
central part of the back side of the running belt. If your hands can grab a little
silicone oil (feel slightly moist), that means you do not need to inject silicone oil.
If the running plate is dry and no silicone oil adhered to your hand, then you
need to inject silicone oil.
